BH GSO ISO 15442:2024
ISO 15442:2005
Bahraini Standard
Current Edition
·
Approved on
14 April 2024
Cranes – Safety requirements for loader cranes
BH GSO ISO 15442:2024 Files
English
64 Pages
Current Edition
Reference Language
84.79 BHD
BH GSO ISO 15442:2024 Scope
This International Standard specifies minimum requirements for design, calculation, examinations and tests of
hydraulic powered loader cranes and their mountings on to vehicles or static foundations.
This International Standard applies to all new loader cranes manufactured one year after its publication. It is
not the intent of this International Standard to require the retrofitting of existing loader cranes.
This International Standard does not apply to loader cranes used on board ships or floating structures and to
articulated boom system cranes which are designed as total integral parts of special equipment such as
forwarders.
The hazards covered by this International Standard are identified in Clause 4.
This International Standard does not cover hazards related to the lifting of persons.
NOTE 1 Hoists will be covered by a special standard.
NOTE 2 The use of cranes for the lifting of persons may be subject to specific national regulations.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS

BH GSO 42:2015
GSO 42:2015
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS


GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS

BH GSO 159:2015
GSO 159:1993
Bahraini Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS


Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron

GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers


GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions


GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors

