BH GSO ISO 3269:2024
ISO 3269:2000
Bahraini Standard
Current Edition
·
Approved on
21 November 2024
Fasteners - Acceptance inspection
BH GSO ISO 3269:2024 Files
No files for this standard are available in the store currently.
BH GSO ISO 3269:2024 Scope
1.1 This International Standard specifies the acceptance inspection procedure that the purchaser of fasteners
must follow in order to determine whether a lot of fasteners will be accepted or rejected in cases where no other
such procedure was agreed with the supplier at the time the fasteners were ordered. Additional requirements for
acceptance may be included in a specific product standard (for example, one on prevailing torque-type nuts). The
same procedure is also to be applied in cases where conformance to specification is disputed.
1.2 This International Standard is applicable to bolts, screws, studs, nuts, pins, washers, blind rivets and other
related fasteners not intended for high volume machine assembly, special-purpose applications or specially
engineered applications requiring greater in-process control and lot traceability (see the note in the introduction).
The procedure for these products shall be agreed upon by the supplier and the purchaser prior to the confirmation
of the order.
1.3 This International Standard is applicable only to fully manufactured products; it neither implies nor includes
any particular in-process control procedure or inspection during production.
1.4 The production of accessories, services and partially fabricated parts (for example, washers, nuts, plating,
heat treatment and blanks) for use in the manufacture of fasteners may be subcontracted to other suppliers by the
fastener supplier. Nevertheless, the supplier of the final, finished product shall be solely responsible for the
fastener’s quality.
The requirements of this International Standard apply only to the condition of fasteners at the time of delivery. Any
process carried out after receipt (for example, plating) will invalidate the requirements of this International Standard.
1.5 Annex B (informative) offers guidance to, and an explanation of, the principles upon which this International
Standard is based.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO ISO 5393:2026
ISO 5393:2017
Gulf Standard
Rotary tools for threaded fasteners — Performance test method
GSO ISO 11681-2:2026
ISO 11681-2:2022
Gulf Standard
Machinery for forestry — Portable chain-saw safety requirements and testing — Part 2: Chain-saws for tree service
GSO ISO 8741:2026
ISO 8741:2025
Gulf Standard
Fasteners — Reverse-taper grooved pins — Half-length progressive grooves
GSO ISO 8740:2026
ISO 8740:2025
Gulf Standard
Fasteners — Parallel grooved pins, with chamfer point — Full-length diamond grooves