BH GSO OIML D31:2023
OIML D31:2019
Bahraini Standard
Current Edition
·
Approved on
10 December 2023
General requirements for software controlled measuring instruments
BH GSO OIML D31:2023 Files
No files for this standard are available in the store currently.
Obtaining this standard through the store is currently unavailable. You can acquire it directly from its source.
BH GSO OIML D31:2023 Scope
This International Document specifies the general requirements applicable to legally relevant software-related functionality and security in measuring instruments and gives guidance for verifying the compliance of an instrument with these requirements.
This Document shall be taken into consideration by the OIML Technical Committees and Subcommittees as a basis for establishing specific software requirements and procedures in OIML Recommendations applicable to particular categories of measuring instruments (hereafter termed “relevant Recommendations”).
The instructions given in this Document apply only to software-controlled measuring instruments or their components.
Note 1: This Document does not cover all the technical requirements specific to software-controlled measuring instruments; these requirements are to be given in the relevant Recommendation, e.g. for weighing instruments, water meters, etc.
Note 2: This Document addresses some aspects concerning data security. In addition, national regulations for this area need to be considered.
Best Sellers From Metrology Sector
GSO OIML R87:2021
OIML R87:2016
Gulf Standard
Quantity of product in prepackages
BH GSO OIML R87:2022
OIML R87:2016
Bahraini Standard
Quantity of product in prepackages
GSO OIML R79:2021
OIML R79:2015
Gulf Standard
Labeling requirements for prepackages
BH GSO OIML R79:2022
OIML R79:2015
Bahraini Standard
Labeling requirements for prepackages
Recently Published from Metrology Sector
GSO ISO 10713:2026
ISO 10713:2025
Gulf Standard
Jewellery and precious metals — Gold alloy coatings
GSO ISO 20816-2:2026
ISO 20816-2:2017
Gulf Standard
Mechanical vibration — Measurement and evaluation of machine vibration — Part 2: Land-based gas turbines, steam turbines and generators in excess of 40 MW, with fluid-film bearings and rated speeds of 1 500 r/min, 1 800 r/min, 3 000 r/min and 3 600 r/min
GSO ISO 5059-1:2026
ISO 5059-1:2025
Gulf Standard
Geometrical product specifications (GPS) — Dimensional measuring equipment — Part 1: Design and metrological characteristics of two-point inside micrometers
GSO ISO 25178-602:2026
ISO 25178-602:2025
Gulf Standard
Geometrical product specifications (GPS) — Surface texture: Areal — Part 602: Design and characteristics of non-contact (confocal chromatic probe) instruments