ISO 4359:2022

International Standard   Current Edition · Approved on 19 December 2022

Flow measurement structures — Rectangular, trapezoidal and U-shaped flumes

ISO 4359:2022 Files

English 79 Pages
Current Edition
89.74 BHD

ISO 4359:2022 Scope

This document specifies methods for the measurement of flow in rivers and artificial channels under steady or slowly varying flow conditions, using certain types of critical-depth flumes (also known as “standing-wave flumes”). A wide variety of flumes has been developed, but only those critical-depth flumes which have received general acceptance after adequate research and field testing, and which therefore do not require in situ calibration, are considered herein.

The flow conditions considered are uniquely dependent on the upstream head, i.e. subcritical flow must exist upstream of the flume, after which the flow accelerates through the contraction and passes through its critical depth (see Figure 1). The water level downstream of the structure is low enough to have no influence upon its performance.

This document is applicable to three commonly used types of flumes, covering a wide range of applications, namely rectangular-throated, trapezoidal-throated and U-throated. The hydraulic theory behind this document was presented in Reference [7].

This document is not applicable to a form of flume referred to in the literature (sometimes called a “Venturi” flume) in which the flow remains subcritical throughout.

NOTE      The Venturi form of flume is based on the same principle as a Venturi meter used within a closed conduit system and relies upon gauging the head at two locations and the application of Bernoulli’s energy formula.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 150-2:2015
GSO 150-2:2013 
Bahraini Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 2055-1:2016
GSO 2055-1:2015 
Bahraini Technical Regulation
HALAL FOOD - Part 1 : General Requirements
GSO 2055-1:2015
 
Gulf Technical Regulation
HALAL FOOD - Part 1 : General Requirements

Recently Published

ISO/IEC 23009-9:2025
 
International Standard
Information technology — Dynamic adaptive streaming over HTTP (DASH) — Part 9: Redundant encoding and packaging for segmented live media (REaP)
ISO/IEC TR 27599:2025
 
International Standard
Information technology — Brain-computer interfaces — Use cases
ISO 4517:2025
 
International Standard
Physical vapor deposition (PVD) coatings — Contact angle measurement of metallic hydrophobic PVD coatings
ISO 15237:2025
 
International Standard
Coal — Determination of total mercury