ISO 5754:2023

مواصفة قياسية دولية   الإصدار الحالي
اعتمدت بتاريخ  21 سبتمبر 2023

Sintered metal materials, excluding hardmetals — Unnotched impact test piece

الاختبار الميكانيكي للمعادن
* الاختبارات الميكانيكية بصفة عامة، انظر 19.060

ملفات الوثيقة ISO 5754:2023

null صفحات
الإصدار الحالي

مجال الوثيقة ISO 5754:2023

This document specifies the dimensions of an unnotched impact test piece of sintered metal materials. The test piece may be obtained directly by pressing and sintering or by machining a sintered part.

This document applies to all sintered metals and alloys, with the exception of hardmetals. However, for certain materials (for example, materials with low porosity or materials with high ductility), it may be more appropriate to use a notched test piece which, in this case, will give results with less scatter. (In this case, refer to ISO 148-1.)

NOTE            For porous sintered materials, the results obtained from impact tests on unnotched specimens according to this standard are not fully comparable with results obtained from tests on solid metals tested on notched specimens.

الأكثر مبيعاً

GSO 150-2:2013
 
مواصفة قياسية خليجية
فترات صلاحية المنتجات الغذائية - الجزء الثاني : فترات الصلاحية الاختيارية
BH GSO 150-2:2015
GSO 150-2:2013 
مواصفة قياسية بحرينية
فترات صلاحية المنتجات الغذائية - الجزء الثاني : فترات الصلاحية الاختيارية
BH GSO 150-1:2015
GSO 150-1:2013 
لائحة فنية بحرينية
فترات صلاحية المنتجات الغذائية - الجزء الأول : فترات الصلاحية الإلزامية
GSO 150-1:2013
 
لائحة فنية خليجية
فترات صلاحية المنتجات الغذائية - الجزء الأول : فترات الصلاحية الإلزامية

اعتمدت مؤخراً

ISO 21978:2023
 
مواصفة قياسية دولية
Air to water heat pumps — Testing and rating at part load conditions and calculation of seasonal coefficient of performance for space heating
ISO 12643-2:2023
 
مواصفة قياسية دولية
Graphic technology — Safety requirements for graphic technology equipment and systems — Part 2: Prepress and press equipment and systems
ISO 4266-2:2023
 
مواصفة قياسية دولية
Petroleum and liquid petroleum products — Measurement of level and temperature in storage tanks by automatic methods — Part 2: Measurement of level in marine vessels
ISO 12643-3:2023
 
مواصفة قياسية دولية
Graphic technology — Safety requirements for graphic technology equipment and systems — Part 3: Binding and finishing equipment and systems