BH GSO ISO 5414-2:2016
ISO 5414-2:2002
Bahraini Standard
Current Edition
·
Approved on
10 February 2016
Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools -- Part 2: Connecting dimensions of chucks and designation
BH GSO ISO 5414-2:2016 Files
English
10 Pages
Current Edition
Reference Language
BHD
30.29
BH GSO ISO 5414-2:2016 Scope
This part of ISO 5414 specifies the dimensions of tool chucks (end mill holders) with clamp screws for tools with flatted cylindrical shanks in accordance with ISO 3338-2. It also specifies the designations of these chucks.
Two types of connection are defined:
— chucks with 7/24 taper shanks in accordance with ISO 297 for manual changers and with ISO 7388-1 for automatic changers, for tool shanks with either single flat or a double flat for manual and automatic changers;
NOTE 1 This part of ISO 5414 specifies the dimensions of tool chucks with 7/24 taper shanks No. 30 for automatic changers although these are not standardized.
— chucks with Morse taper shanks in accordance with ISO 296 and ISO 5413 for tool shanks with a single flat only.
NOTE 2 The dimensions of the driving system of the tool shanks are dealt with in ISO 5414-1.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993
Bahraini Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO EN 131-3:2018+A1:2026
EN 131-3:2018+A1:2025
Gulf Standard
Ladders - Part 3: Marking and user instructions
GSO ISO 22705-3:2026
ISO 22705-3:2024
Gulf Standard
Springs — Measurement and test parameters — Part 3: Cold formed cylindrical helical torsion springs
GSO ISO 14732:2026
ISO 14732:2025
Gulf Standard
Welding personnel — Qualification testing of welding operators and weld setters for mechanized and automatic welding of metallic materials
GSO EN 1514-4:2026
EN 1514-4:1997
Gulf Standard
Flanges and their joints - Dimensions of gaskets for PN-designated flanges - Part 4: Corrugated, flat or grooved metallic and filled metallic gaskets for use with steel flanges