BH GSO ASTM D1298:2017

Bahraini Standard   Current Edition
Approved on  21 June 2017

Standard Test Method for Density, Relative Density, or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method

BH GSO ASTM D1298:2017 Files

English 8 Pages
Current Edition Reference Language

BH GSO ASTM D1298:2017 Scope

1.1 This test method covers the laboratory determination using a glass hydrometer in conjunction with a series of calculations, of the density, relative density, or API gravity of crude petroleum, petroleum products, or mixtures of petroleum and nonpetroleum products normally handled as liquids, and having a Reid vapor pressure of 101.325 kPa (14.696 psi) or less. Values are determined at existing temperatures and corrected to 15°C or 60°F by means of a series of calculations and international standard tables. 1.2 The initial hydrometer readings obtained are uncorrected hydrometer readings and not density measurements. Readings are measured on a hydrometer at either the reference temperature or at another convenient temperature, and readings are corrected for the meniscus effect, the thermal glass expansion effect, alternate calibration temperature effects and to the reference temperature by means of the Petroleum Measurement Tables; values obtained at other than the reference temperature being hydrometer readings and not density measurements. 1.3 Readings determined as density, relative density, or API gravity can be converted to equivalent values in the other units or alternate reference temperatures by means of Interconversion Procedures (API MPMS Chapter 11.5), or Adjunct to D1250 Guide for Petroleum Measurement Tables (API MPMS Chapter 11.1), or both, or tables, as applicable. 1.4 The initial hydrometer readings determined in the laboratory shall be recorded before performing any calculations. The calculations required in Section 10 shall be applied to the initial hydrometer reading with observations and results reported as required by Section 11 prior to use in a subsequent calculation procedure (ticket calculation, meter factor calculation, or base prover volume determination). 1.5 Annex A1 contains a procedure for verifying or certifying the equipment for this test method. 1.6 The values stated in SI units are to be regarded as standard. The values given in parentheses are provided for information only. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Best Sellers From Oil and Gas Sector

GSO 1785:2013
 
Gulf Technical Regulation
Lubricating Oils for Internal Combustion Engines API Classifications
BH GSO 1785:2015
GSO 1785:2013 
Bahraini Technical Regulation
Lubricating Oils for Internal Combustion Engines API Classifications
GSO 672:2010
 
Gulf Standard
Liquefied petroleum gases (LPG) for household use( mixture of commerical propane and butane).
GSO 1180:2021
 
Gulf Standard
Automatic transmission fluid (ATF)

Recently Published from Oil and Gas Sector

GSO ASTM D341:2022
ASTM D341:20e1 
Gulf Standard
Standard Practice for Viscosity-Temperature Equations and Charts for Liquid Petroleum or Hydrocarbon Products
GSO ISO 10855-1:2022
ISO 10855-1:2018 
Gulf Standard
Offshore containers and associated lifting sets — Part 1: Design, manufacture and marking of offshore containers
GSO ASTM D7603:2022
ASTM D7603:13 
Gulf Standard
Standard Test Method for Determination of Storage Stability and Compatibility in Automotive Gear Oils
GSO ASTM D6217:2022
ASTM D6217:18 
Gulf Standard
Standard Test Method for Particulate Contamination in Middle Distillate Fuels by Laboratory Filtration