BH GSO ISO 18375:2022

ISO 18375:2016
Bahraini Standard   Current Edition · Approved on 28 April 2022

Heavy commercial vehicles and buses — Test method for yaw stability — Sine with dwell test

BH GSO ISO 18375:2022 Files

English 13 Pages
Current Edition Reference Language
40.18 BHD

BH GSO ISO 18375:2022 Scope

ISO 18375:2016 describes an open-loop test method for determining the yaw stability of a vehicle on a low friction road surface. It applies to heavy vehicles, that is commercial vehicles, commercial vehicle combinations, buses and articulated buses as defined in ISO 3833 (trucks and trailers with maximum weight above 3,5 tonnes and buses and articulated buses with maximum weight above 5 tonnes, according to ECE and EC vehicle classification, categories M3, N2, N3, O3 and O4).

The method is intended for vehicles equipped with electronic yaw-stability control systems.

As the results of this test depend largely on local and temporary changes in road surface friction, this International Standard gives recommendations about keeping the friction level as uniform as possible for good reproducibility of the test results.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015 
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993 
Bahraini Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022 
Gulf Standard
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 5: Test methods for evaluating plastic liners
GSO ISO 4211-5:2024
ISO 4211-5:2021 
Gulf Standard
Furniture — Tests for surface finishes — Part 5: Assessment of resistance to abrasion