BH GSO IEC 62841-3-7:2024

IEC 62841-3-7:2020
Bahraini Standard   Current Edition · Approved on 14 April 2024

Electric motor-operated hand-held tools, transportable tools and lawn and garden machinery - Safety - Part 3-7: Particular requirements for transportable wall saws

BH GSO IEC 62841-3-7:2024 Files

English 58 Pages
Current Edition Reference Language

BH GSO IEC 62841-3-7:2024 Scope

IEC 62841-3-7:2020 This document applies to transportable wall saws guided by a track guiding system intended for dry cutting or to be connected to a liquid system for cutting concrete, stone or similar material by means of a diamond wheel. The rated speed of the diamond wheel does not exceed a peripheral speed of 100 m/s at rated capacity.
The rated voltage is not more than 250 V for single-phase a.c. or d.c. tools, and 480 V for three-phase a.c. tools.
This document does not apply to transportable wall saws that are intended to be left unattended while performing an operation.
This document does not apply to transportable wall saws that employ hydraulic systems.
This document does not apply to hand-held cut-off machines.

Best Sellers From Electrical Sector

GSO 2530:2016
 
Gulf Standard
Energy Labelling And Minimum Energy Performance Requirements For Air-Conditioners
GSO 34:2007
 
Gulf Technical Regulation
LEAD-ACID STARTER BATTERIES USED FOR MOTOR VEHICLES AND INTERNAL COMBUSTION ENGINES
BH GSO 34:2015
GSO 34:2007 
Bahraini Technical Regulation
LEAD-ACID STARTER BATTERIES USED FOR MOTOR VEHICLES AND INTERNAL COMBUSTION ENGINES
GSO 35:2007
 
Gulf Standard
Methods of test for lead-acid starter batteries used for motor vehicles and internal combustion engines

Recently Published from Electrical Sector

GSO IEC 60512-99-003:2024
IEC 60512-99-003:2023 
Gulf Standard
Connectors for electrical and electronic equipment - Tests and measurements - Part 99-003: Endurance test schedules - Test 99c: Test schedule for balanced single-pair connectors separating (unmating) under electrical load
GSO IEC 60794-1-309:2024
IEC 60794-1-309:2023 
Gulf Standard
Optical fibre cables - Part 1-309: Generic specification - Basic optical cable test procedures - Cable element test methods - Bleeding and evaporation of filling or flooding compounds, Method G9
GSO IEC 63119-1:2024
IEC 63119-1:2019 
Gulf Standard
Information exchange for electric vehicle charging roaming service - Part 1: General
GSO IEC TR 63401-1:2024
IEC TR 63401-1:2022 
Gulf Standard
Dynamic characteristics of inverter-based resources in bulk power systems - Part 1: Interconnecting inverter-based resources to low short circuit ratio AC networks