BH GSO EN 13136:2013+A1:2024
EN 13136:2013+A1:2018
Bahraini Standard
Current Edition
·
Approved on
21 November 2024
Refrigerating systems and heat pumps - Pressure relief devices and their associated piping - Methods for calculation
BH GSO EN 13136:2013+A1:2024 Files
No files for this standard are available in the store currently.
Obtaining this standard through the store is currently unavailable. You can acquire it directly from its source.
BH GSO EN 13136:2013+A1:2024 Scope
1.1 This European Standard describes the calculation of mass flow for sizing pressure relief devices for components of refrigerating systems.
NOTE The term "refrigerating system" used in this European Standard includes heat pumps.
1.2 This European Standard describes the calculation of discharge capacities for pressure relief valves and other pressure relief devices in refrigerating systems including the necessary data for sizing these when relieving to atmosphere or to components within the system at lower pressure.
1.3 This European Standard specifies the requirements for selection of pressure relief devices to prevent excessive pressure due to internal and external heat sources, the sources of increasing pressure (e.g. compressor, heaters, etc.) and thermal expansion of trapped liquid.
1.4 This European Standard describes the calculation of the pressure loss in the upstream and downstream line of pressure relief valves and other pressure relief devices and includes the necessary data.
1.5 This European Standard refers to other relevant standards in Clause 5.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 2698:2022
Gulf Standard
Technical Requirements for Electric Vehicles
Recently Published from Mechanical Sector
GSO ISO 8741:2026
ISO 8741:2025
Gulf Standard
Fasteners — Reverse-taper grooved pins — Half-length progressive grooves
GSO ISO 8740:2026
ISO 8740:2025
Gulf Standard
Fasteners — Parallel grooved pins, with chamfer point — Full-length diamond grooves
GSO ISO 34505:2026
ISO 34505:2025
Gulf Standard
Road vehicles — Test scenarios for automated driving systems — Scenario evaluation and test case generation
GSO ISO 22705-3:2026
ISO 22705-3:2024
Gulf Standard
Springs — Measurement and test parameters — Part 3: Cold formed cylindrical helical torsion springs