GSO ISO 234-1:2013
ISO 234-1:1983
Gulf Standard
Current Edition
·
Approved on
09 September 2013
Files and rasps -- Part 1: Dimensions
GSO ISO 234-1:2013 Files
English
6 Pages
Current Edition
Reference Language
BHD
19.89
GSO ISO 234-1:2013 Scope
Abstract
In contrast to the previous edition (ISO 234-1975), this part of ISO 234 is limited to the most commonly used files and rasps. Does not apply to files and rasps of special manufacture as well as precision files with milled teeth. Specifies the lengths and cross-sections of engineers' files with double cut taper saw files with single cut, mill files and rasps.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993
Bahraini Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO ISO 22705-3:2026
ISO 22705-3:2024
Gulf Standard
Springs — Measurement and test parameters — Part 3: Cold formed cylindrical helical torsion springs
GSO EN 131-3:2018+A1:2026
EN 131-3:2018+A1:2025
Gulf Standard
Ladders - Part 3: Marking and user instructions
GSO ISO 8741:2026
ISO 8741:2025
Gulf Standard
Fasteners — Reverse-taper grooved pins — Half-length progressive grooves
GSO ISO 8740:2026
ISO 8740:2025
Gulf Standard
Fasteners — Parallel grooved pins, with chamfer point — Full-length diamond grooves