GSO ISO 1641-1:2013
ISO 1641-1:2003
Gulf Standard
Current Edition
·
Approved on
31 December 2013
End mills and slot drills -- Part 1: Milling cutters with cylindrical shanks
GSO ISO 1641-1:2013 Files
English
5 Pages
Current Edition
Reference Language
30.49 BHD
GSO ISO 1641-1:2013 Scope
This part of ISO 1642 specifies the general dimensions of the following milling cutters with plain cylindrical, flatted cylindrical and threaded shanks:
— end mills, flat-ended or ball-nosed — standard series and long series;
— slot drills — short series and standard series.
The dimensional characteristics of cylindrical shanks are in accordance with ISO 3338-1, ISO 3338-2 and ISO 3338-3.
NOTE These same milling cutters with Morse taper shanks having a tapped hole are dealt with in ISO 1641-2, those with 7/24 taper shanks in ISO 1641-3.
This part of ISO 1641 does not apply to solid hardmetal end mills and slot drills.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993
Bahraini Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO 376:1994
Gulf Standard
Code of practice for the inspection and testing of steam and hot water boilers -- Part 6: Periodic internal inspection
GSO 1616:2002
Gulf Standard
Domestic and contract furniture-part 2 : methods of test for settees.
GSO 198:1994
Gulf Standard
CHEMICAL ANALYSIS OF CARBON
STEEL – DETERMINATION
OF NITROGEN
GSO 1620:2002
Gulf Standard
Domestic and contact furiniture -part 4 :methods of testing tables.