GSO ISO 10988:2016

ISO 10988:2011
Gulf Standard   Current Edition · Approved on 22 December 2016

Equipment for crop protection -- Knapsack motorized air-assisted sprayers -- Test methods and performance limits

GSO ISO 10988:2016 Files

English 19 Pages
Current Edition Reference Language
BHD 61.95

GSO ISO 10988:2016 Scope

This International Standard specifies the requirements, test methods and minimum performance limits for knapsack motorized air-blast (twin-fluid) sprayers and air-assisted centrifugal sprayers as defined in ISO 5681. It is applicable to those integrally powered knapsack sprayers, equipped with an engine and carried by the operator, intended primarily for use in agriculture and horticulture (hereafter referred to as “sprayers”). It is not applicable to hydraulic pressure sprayers, thermal sprayers or cold foggers; nor is it applicable to sprayers adapted for the application of dry material. It addresses general operating parameters as well as the potential deposition of spray droplets under specified controlled conditions. It does not deal with the safety of the operator in the use of the sprayers (see ISO 28139)

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015 
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993 
Bahraini Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO EN 131-3:2018+A1:2026
EN 131-3:2018+A1:2025 
Gulf Standard
Ladders - Part 3: Marking and user instructions
GSO ISO 22705-3:2026
ISO 22705-3:2024 
Gulf Standard
Springs — Measurement and test parameters — Part 3: Cold formed cylindrical helical torsion springs
GSO ISO 14732:2026
ISO 14732:2025 
Gulf Standard
Welding personnel — Qualification testing of welding operators and weld setters for mechanized and automatic welding of metallic materials
GSO EN 1514-4:2026
EN 1514-4:1997 
Gulf Standard
Flanges and their joints - Dimensions of gaskets for PN-designated flanges - Part 4: Corrugated, flat or grooved metallic and filled metallic gaskets for use with steel flanges