GSO ISO 14373:2021

ISO 14373:2015
Gulf Standard   Current Edition · Approved on 01 July 2021

Resistance welding — Procedure for spot welding of uncoated and coated low carbon steels

GSO ISO 14373:2021 Files

GSO ISO 14373:2021 Scope

ISO 14373:2015 specifies requirements for resistance spot welding in the fabrication of assemblies of uncoated and metallic coated low carbon steel, comprising two or three sheets of metal, where the maximum single sheet thickness of components to be welded is within the range 0,4 mm to 3 mm, for the following materials: uncoated steels; hot-dip zinc or iron-zinc alloy (galvannealed) coated steel; electrolytic zinc, zinc-iron, or zinc-nickel coated steel; aluminium coated steel; zinc-aluminium coated steel. It is applicable to welding of sheets of the same or dissimilar thickness, where the thickness ratio is less than or equal to 3:1. It applies to the welding of three thicknesses, where the total thickness is less than or equal to 9 mm.

Welding with the following types of equipment is within its scope: pedestal welding equipment; gun welders; automatic welding equipment where the components are fed by robots or automatic feeding equipment; multi welders; robotic welders. It also gives information, for guidance only, on appropriate welding equipment on spot welding conditions.

The welding of organic coated or primer coated steels is not within its scope.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 98:1988
 
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF INTERIOR MATERIALS AND THEIR TESTING METHODS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
GSO 1780:2010
 
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements

Recently Published from Mechanical Sector

GSO ISO 8741:2026
ISO 8741:2025 
Gulf Standard
Fasteners — Reverse-taper grooved pins — Half-length progressive grooves
GSO ISO 8740:2026
ISO 8740:2025 
Gulf Standard
Fasteners — Parallel grooved pins, with chamfer point — Full-length diamond grooves
GSO ISO 34505:2026
ISO 34505:2025 
Gulf Standard
Road vehicles — Test scenarios for automated driving systems — Scenario evaluation and test case generation
GSO ISO 6535:2026
ISO 6535:2015 
Gulf Standard
Portable chain-saws — Chain brake performance