GSO IEC 62514:2021

IEC 62514:2010
Gulf Standard   Current Edition · Approved on 01 July 2021

Multimedia gateway in home networks - Guidelines

GSO IEC 62514:2021 Files

GSO IEC 62514:2021 Scope

IEC 62514:2010(E) describes the general guidelines for typical applications of the home multimedia gateway in home networks supporting IP networking. It specifies recommended functions and services to be supported by the home multimedia gateway and, where appropriate, refers to existing standards supported in the market. For general requirements, it is expected that widely adopted standards and technologies will be considered by implementers. It gives supplementary application to IEC 62481, which specifies a central management model in home network supporting various interfaces in LAN side and WAN side (optional).

Best Sellers From Electrical Sector

GSO 2530:2016
 
Gulf Standard
Energy Labelling And Minimum Energy Performance Requirements For Air-Conditioners
GSO 34:2007
 
Gulf Technical Regulation
LEAD-ACID STARTER BATTERIES USED FOR MOTOR VEHICLES AND INTERNAL COMBUSTION ENGINES
BH GSO 34:2015
GSO 34:2007 
Bahraini Technical Regulation
LEAD-ACID STARTER BATTERIES USED FOR MOTOR VEHICLES AND INTERNAL COMBUSTION ENGINES
GSO 35:2007
 
Gulf Standard
Methods of test for lead-acid starter batteries used for motor vehicles and internal combustion engines

Recently Published from Electrical Sector

GSO IEC 61558-2-2:2024
IEC 61558-2-2:2022 
Gulf Standard
Safety of transformers, reactors, power supply units and combinations thereof - Part 2-2: Particular requirements and tests for control transformers and power supply units incorporating control transformers
GSO IEC 60664-1:2024
IEC 60664-1:2020 
Gulf Standard
Insulation coordination for equipment within low-voltage supply systems - Part 1: Principles, requirements and tests
GSO IEC 61936-2:2024
IEC 61936-2:2023 
Gulf Standard
Power installations exceeding 1 kV AC and 1,5 kV DC - Part 2: DC
GSO IEC TS 62915:2024
IEC TS 62915:2023 
Gulf Standard
Photovoltaic (PV) modules - Type approval, design and safety qualification - Retesting