GSO ISO 1119:2021
ISO 1119:2011
Gulf Standard
Current Edition
·
Approved on
01 July 2021
Geometrical product specifications (GPS) — Series of conical tapers and taper angles
GSO ISO 1119:2021 Files
English
8 Pages
Current Edition
Reference Language
BHD
30.33
GSO ISO 1119:2021 Scope
ISO 1119:2011 provides calculated values for a series of cones or conical tapers, ranging from 120° to less than 1°, or ratios from 1:0,289 to 1:500, intended for general use in technical engineering.
It applies only to plain conical surfaces, and excludes prismatic pieces, taper threads, bevel gears, etc.
Best Sellers From Metrology Sector
GSO OIML R87:2021
OIML R87:2016
Gulf Standard
Quantity of product in prepackages
BH GSO OIML R87:2022
OIML R87:2016
Bahraini Standard
Quantity of product in prepackages
GSO OIML R79:2021
OIML R79:2015
Gulf Standard
Labeling requirements for prepackages
BH GSO OIML R79:2022
OIML R79:2015
Bahraini Standard
Labeling requirements for prepackages
Recently Published from Metrology Sector
GSO ISO 5059-1:2026
ISO 5059-1:2025
Gulf Standard
Geometrical product specifications (GPS) — Dimensional measuring equipment — Part 1: Design and metrological characteristics of two-point inside micrometers
GSO ISO 25178-602:2026
ISO 25178-602:2025
Gulf Standard
Geometrical product specifications (GPS) — Surface texture: Areal — Part 602: Design and characteristics of non-contact (confocal chromatic probe) instruments
GSO ISO 6425:2026
ISO 6425:2018
Gulf Standard
Horology — Divers' watches
GSO ISO 20816-2:2026
ISO 20816-2:2017
Gulf Standard
Mechanical vibration — Measurement and evaluation of machine vibration — Part 2: Land-based gas turbines, steam turbines and generators in excess of 40 MW, with fluid-film bearings and rated speeds of 1 500 r/min, 1 800 r/min, 3 000 r/min and 3 600 r/min