GSO ISO 15876-1:2021

Gulf Standard   ACTIVE

Plastics piping systems for hot and cold water installations — Polybutene (PB) — Part 1: General

Scope

ISO 15876-1:2017 specifies the general aspects of polybutene-1 (PB-1) piping systems intended to be used for hot and cold water installations within buildings for the conveyance of water whether or not intended for human consumption (domestic systems) and for heating systems, under design pressures and temperatures according to the class of application (see Table 1).

The designation polybutene is used together with the abbreviation PB throughout this document.

ISO 15876-1:2017 covers a range of service conditions (application classes) and design pressure and pipe dimension classes. Values of TD, Tmax and Tmal in excess of those in Table 1 do not apply.

NOTE It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.

It also specifies the test parameters for the test methods referred to in this document.

In conjunction with the other parts of ISO 15876, this document is applicable to PB pipes, fittings, their joints and to joints with components of other plastics and non-plastics materials intended to be used for hot and cold water installations.

Adoption without modification
ISO 15876-1:2017
01 July 2021
Water supply systems
Including water meters in buildings

Files

 
 

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015 
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993 
Bahraini Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO ECE 30:2021
ECE 30:2017 
Gulf Standard
Tyres for passenger cars and their trailers
GSO ECE 60:2021
ECE 60:2013 
Gulf Standard
Uniform provisions concerning the approval of two-wheeled motor cycles and mopeds with regard to driver-operated controls including the identification of controls, tell-tales and indicators
GSO ECE 76:2021
ECE 76:1988 
Gulf Standard
UNIFORM PROVISIONS CONCERNING THE APPROVAL OF HEADLAMPS FOR MOPEDS EMITTING A DRIVING BEAM AND A PASSING BEAM
GSO EN 1074-3:2021
EN 1074-3:2000 
Gulf Standard
Valves for water supply – Fitness for purpose requirements and appropriate verification tests – Part 3: Check valves