GSO EN 12288:2021
Gulf Standard
ACTIVE
Industrial valves -- Copper alloy gate valves
Scope
This European Standard applies to copper alloy gate valves for general use having flanged, threaded, capillary, compression or loose nut/union body ends. This European Standard specifies the design and performance requirements including materials, pressure/temperature ratings, dimensions, test procedures and marking. For some specific fields of application, for example, drinking water or gas, valves to this European Standard can be used provided the requirements of the relevant performance standards are met. Approval by the relevant regulatory body may be required. The range of nominal sizes is DN 8 to DN 500 and of nominal diameters is 8 mm to 110 mm. The range of pressure designations covered is PN 6 ; PN 10 ; PN 16 ; PN 20 ; PN 25 ; PN 32 ; PN 40 ; PN 63 ; Class 150 and Class 300. For the applicability of each nominal size/diameter and each pressure designation to the different types of valve end, see 4.1.
Files
No files are available for this standard right now!
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993
Bahraini Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO ECE 30:2021
ECE 30:2017
Gulf Standard
Tyres for passenger cars and their trailers
GSO ECE 60:2021
ECE 60:2013
Gulf Standard
Uniform provisions concerning the approval of two-wheeled motor cycles and mopeds with regard to driver-operated controls including the identification of controls, tell-tales and indicators
GSO ECE 76:2021
ECE 76:1988
Gulf Standard
UNIFORM PROVISIONS CONCERNING THE APPROVAL OF HEADLAMPS FOR MOPEDS EMITTING A DRIVING BEAM AND A PASSING BEAM
GSO EN 1074-3:2021
EN 1074-3:2000
Gulf Standard
Valves for water supply – Fitness for purpose requirements and appropriate verification tests – Part 3: Check valves