GSO ISO 17842-1:2022

Gulf Standard   Current Edition
Approved on  12 May 2022

Safety of amusement rides and amusement devices — Part 1: Design and manufacture

Playgrounds
Including amusement rides and devices

GSO ISO 17842-1:2022 Files

GSO ISO 17842-1:2022 Scope

ISO 17824-1:2015 specifies the minimum requirements necessary to ensure the safe design, calculation, manufacture, and installation of the following: mobile, temporary or permanently installed machinery and structures, e.g. roundabouts, swings, boats, Ferris wheels, roller coasters, chutes, grandstands, membrane or textile structures, booths, stages, side shows, and structures for artistic aerial displays. These amusement devices are intended to be installed both repeatedly without degradation or loss of integrity, and temporarily or permanently in fairgrounds and amusement parks or any other locations. Fixed grandstands, construction site installations, scaffolding, removable agricultural structures and simple coin operated children's amusement devices intended for up to 3 children are not covered.

It can nevertheless be used in the design of any similar structural or passenger-carrying device.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015 
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993 
Bahraini Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO EN 17038-1:2023
EN 17038-1:2019 
Gulf Standard
Pumps - Methods of qualification and verification of the Energy Efficiency Index for rotodynamic pump units - Part 1: General requirements and procedures for testing and calculation of Energy Efficiency Index (EEI)
GSO EN 14452:2023
EN 14452:2005 
Gulf Standard
Devices to prevent pollution by backflow of potable water - Pipe interrupter with atmospheric vent and moving element DN 10 to DN 20 - Family D, type B
GSO ISO 11298-4:2023
ISO 11298-4:2021 
Gulf Standard
Plastics piping systems for renovation of underground water supply networks — Part 4: Lining with cured-in-place pipes
GSO ISO 24528:2023
ISO 24528:2021 
Gulf Standard
Service activities relating to drinking water supply, wastewater and stormwater systems — Guideline for a water loss investigation of drinking water distribution networks