GSO ISO 19085-9:2022

Gulf Standard   Current Edition
Approved on  12 May 2022

Woodworking machines — Safety — Part 9: Circular saw benches (with and without sliding table)

GSO ISO 19085-9:2022 Files

GSO ISO 19085-9:2022 Scope

This document gives the safety requirements and measures for stationary and displaceable circular saw benches (with or without sliding table and/or demountable power feed unit), also known as "table saws" (in the USA), hereinafter referred to as "machines", designed to cut wood and material with similar physical characteristics to wood.

NOTE 1 For the definition of stationary and displaceable machine, see ISO 19085‑1:2017, 3.4 and 3.5.

It deals with all significant hazards, hazardous situations and events as listed in Clause 4 relevant to these machines when they are operated, adjusted and maintained as intended and under the conditions foreseen by the manufacturer including reasonably foreseeable misuse. Also, transport, assembly, dismantling, disabling and scrapping phases are taken into account.

NOTE 2 For relevant but not significant hazards, e.g. sharp edges of the machine frame, see ISO 12100:2010.

It is also applicable to machines fitted with one or more of the following devices, or working unit, whose hazards have been dealt with:

— device for the main saw blade and scoring saw blade to be raised and lowered through the table;

— device to tilt the main saw blade and scoring saw blade for angled cutting;

— device for scoring;

— device for grooving with milling tool with a width not exceeding 20 mm in one pass;

— demountable power feed unit;

— additional manually operated sliding table;

— powered work-piece clamping device.

NOTE 3 Circular saw benches are used for ripping, cross cutting, dimensioning and grooving.

This document does not apply to:

a) transportable/displaceable machines intended for outdoor use on building sites;

NOTE 4 Building site saws (contractor saws) are covered by the requirements of ISO 19085‑10:2018.

b) hand held woodworking machines including any adaptation permitting their use in a different mode, i.e. bench mounting;

c) machines intended for use in a potentially explosive atmosphere;

d) machines manufactured before the date of its publication as an International Standard;

e) transportable machines with a maximum saw blade diameter of ≤315 mm.

NOTE 5 Transportable motor-operated electric tools are dealt with in IEC 62841‑1:2014 and IEC 62841‑3‑1:2014.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015 
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993 
Bahraini Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO EN 17093:2022
EN 17093:2018 
Gulf Standard
Domestic appliances used for drinking water treatment not connected to water supply - Jug water filter systems - Safety and performance requirements, labeling and information to be supplied
GSO ISO 7176-6:2022
ISO 7176-6:2018 
Gulf Standard
Wheelchairs — Part 6: Determination of maximum speed of electrically powered wheelchairs
GSO EN 12572-1:2022
EN 12572-1:2017 
Gulf Standard
Artificial climbing structures - Part 1: Safety requirements and test methods for ACS with protection points
GSO EN 1647:2022
EN 1647:2018 
Gulf Standard
Leisure accommodation vehicles - Caravan holiday homes - Habitation requirements relating to health and safety