GSO ISO 21927-8:2022

Gulf Standard   Current Edition
Approved on  12 May 2022

Smoke and heat control systems — Part 8: Smoke control dampers

Fire protection
Including equipment

GSO ISO 21927-8:2022 Files

GSO ISO 21927-8:2022 Scope

ISO 21927-8:2017 applies to smoke control dampers, placed on the market and intended to operate as part of a pressure differential system or smoke and heat control system. This document specifies requirements and gives reference to the test methods defined for smoke control dampers and their associated components, such as actuators which are intended to be installed in such systems in buildings. Furthermore, provision on marking and information on installation and maintenance of these products are also given.

ISO 21927-8:2017 distinguishes between two categories of smoke control dampers, i.e. single-compartment smoke control dampers and multi‑compartment fire-resisting smoke control dampers.

Smoke control dampers covered by this document can be installed into smoke control system ducts or onto the ducts' surface. They can be installed also into a wall, floor or ceiling/roof elements or onto the surface of these elements.

NOTE To avoid duplication, reference is made to a variety of other standards. To this end, this document can be read in conjunction with EN 13501‑4, EN 1366‑10 and ISO 10294‑1 for details of the furnace testing.

ISO 21927-8:2017 does not consider in detail the detrimental and/or corrosive effects that can be caused by process chemicals present in the atmosphere, which are drawn through the system intentionally or inadvertently.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015 
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993 
Bahraini Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO ISO 7240-23:2023
ISO 7240-23:2013 
Gulf Standard
Fire detection and alarm systems — Part 23: Visual alarm devices
GSO ISO 9343:2023
ISO 9343:2021 
Gulf Standard
Pliers and nippers — Slip joint pliers — Dimensions and test values
GSO ISO 12216:2023
ISO 12216:2020 
Gulf Standard
Small craft — Windows, portlights, hatches, deadlights and doors — Strength and watertightness requirements
GSO ISO 21250-3:2023
ISO 21250-3:2020 
Gulf Standard
Rolling bearings — Noise testing of rolling bearing greases — Part 3: Test and evaluation method MQ