GSO ISO 11148-13:2022

Gulf Standard   Current Edition
Approved on  12 May 2022

Hand-held non-electric power tools — Safety requirements — Part 13: Fastener driving tools

GSO ISO 11148-13:2022 Files

GSO ISO 11148-13:2022 Scope

ISO 11148-13:2017 specifies safety requirements for hand-held non-electric power tools (hereinafter referred to as "fastener driving tools") intended for installation of a fastener (see Annex B), forming a mechanical connection or attachment with the workpiece which are for example wood and wood-based materials, plastic materials, fibre materials (loose or compacted), cementitious materials, metals and combinations of these materials. The fastener driving tools for fasteners can be powered by compressed air or combustible gases (which may be ignited by a battery or accumulator) and the energy is transmitted to an impacted element by an intermediary component that does not leave the device. These tools are intended to be used by one operator and supported by the operator's hand or hands, with or without a suspension, e.g. a balancer.

ISO 11148-13:2017 is applicable to fastener driving tools in which energy is applied to a loaded fastener for the purpose of driving this into a workpiece.

ISO 11148-13:2017 is not applicable to fastener driving tools in which the energy for driving fasteners is drawn from powder-actuated cartridges, hydraulics or from any type of electrical supply.

ISO 11148-13:2017 does not deal with special requirements and modifications of hand-held power tools for the purpose of mounting them in a fixture.

ISO 11148-13:2017 deals with all significant hazards, hazardous situations or hazardous events relevant to fastener driving tools for fasteners when they are used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer, with the exception of the use of power tools in potentially explosive atmospheres.

NOTE ISO 80079?36 gives requirements for non-electrical equipment for potentially explosive atmospheres.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015 
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993 
Bahraini Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO ECE 22:2022
ECE 22:2002 
Gulf Standard
Uniform provisions concerning the approval of protective helmets and their visors for drivers and passengers of motor cycles and mopeds
GSO ISO 19085-9:2022
ISO 19085-9:2019 
Gulf Standard
Woodworking machines — Safety — Part 9: Circular saw benches (with and without sliding table)
GSO EN 17093:2022
EN 17093:2018 
Gulf Standard
Domestic appliances used for drinking water treatment not connected to water supply - Jug water filter systems - Safety and performance requirements, labeling and information to be supplied
GSO ISO 7176-6:2022
ISO 7176-6:2018 
Gulf Standard
Wheelchairs — Part 6: Determination of maximum speed of electrically powered wheelchairs