GSO ASTM D5759:2022
ASTM D5759:12(2020)
Gulf Standard
Current Edition
·
Approved on
12 May 2022
Standard Guide for Characterization of Coal Fly Ash and Clean Coal Combustion Fly Ash for Potential Uses
GSO ASTM D5759:2022 Files
No files for this standard are available in the store currently.
Obtaining this standard through the store is currently unavailable. You can acquire it directly from its source.
GSO ASTM D5759:2022 Scope
1.1 This guide recommends standards for the characterization of fly ash from the combustion of coal, fly ash from coal
combusted in the presence of alkaline materials, and fly ash
from combusted coal in which the flue gases have been treated
with alkaline materials in the presence of the fly ash.
1.2 This guide provides recommended and optional test
methods for fly ash evaluation. Acceptance criteria can be
negotiated between the producer and the user according to the
potential end use.
1.3 The coal fly ash and clean coal combustion fly ash of
this guide do not include the following:
1.3.1 Dusts from kilns producing products such as lime,
portland cement, activated clays, etc.;
1.3.2 By-products of flue gas desulflurization that are not
collected with the primary fly ash removal equipment such as
the baghouse or electrostatic precipitator; and
1.3.3 Fly ash or other combustion products derived from the
burning of waste; municipal, industrial, or commercial garbage; sewage sludge or other refuse, or both; derived fuels;
wood; wood waste products; rice hulls; agriculture waste; or
other non-coal fuels or other such fuels blended with coal, or
some combination thereof.
1.4 Fly ash may contain some trace elements that may affect
performance or potential end use.
1.5 The values stated in inch-pound units are to be regarded
as standard. The values given in parentheses are mathematical
conversions to SI units that are provided for information only
and are not considered standard.
1.6 This standard does not purport to address all of the
safety concerns, if any, associated with its use. It is the
responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the
Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical
Barriers to Trade (TBT) Committee.
Best Sellers From Construction and Building Sector
GSO 1431:2002
Gulf Technical Regulation
Sanitary appliances - pressurized flushing devices

GSO 1427:2008
Gulf Standard
Ceramic Sanitary Appliances - Western Water Closets

BH GSO 1427:2024
GSO 1427:2008
Bahraini Standard
Ceramic Sanitary Appliances - Western Water Closets


GSO 1421:2002
Gulf Technical Regulation
Hollow blocks made from clay for walls

Recently Published from Construction and Building Sector
GSO 2809:2025
Gulf Standard
Nonloadbearing Lightweight Thermal Insulation Concrete Masonry Units Of Foamed Concrete, Lightweight Aggregates Or Sandwich Insulating Layer

GSO 2808:2025
Gulf Standard
Aluminum composite panel for exterior cladding and interior finishing

GSO ASTM C1364:2025
ASTM C1364:23e1
Gulf Standard
Standard Specification for Architectural Cast Stone


GSO ASTM A994:2025
ASTM A994:24
Gulf Standard
Standard Guide for Editorial Procedures and Form of Product Specifications for Steel, Stainless Steel, and Related Alloys

