GSO ASTM D5800:2022

Gulf Standard   Current Edition
Approved on  12 May 2022

Standard Test Method for Evaporation Loss of Lubricating Oils by the Noack Method

Lubricants, industrial oils and related products
Including mineral oils, fluids for metal working and for temporary protection against corrosion

GSO ASTM D5800:2022 Files

GSO ASTM D5800:2022 Scope

1.1 This test method covers four procedures for determining the evaporation loss of lubricating oils (particularly engine oils). The evaporation measured is reported as percent total loss. The test method relates to one set of operating conditions but may be readily adapted to other conditions as required. 1.2 Procedure B and Procedure D that are in the main section of the test method provide equivalent results. Procedures A and C , which are in Annex A1 and Annex A2, have equivalent results. It has been determined that Procedures A and C show a slight bias when compared to Procedures B and D. Procedures B and D give slightly higher results versus Procedures A and C on formulated engine oils, while Procedures B and D give lower results versus Procedures A and C on basestocks. Thus, a correction factor is utilized to convert between the two sets of Procedures based on the fluid type. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Best Sellers From Oil and Gas Sector

GSO 1785:2013
 
Gulf Technical Regulation
Lubricating Oils for Internal Combustion Engines API Classifications
BH GSO 1785:2015
GSO 1785:2013 
Bahraini Technical Regulation
Lubricating Oils for Internal Combustion Engines API Classifications
GSO 672:2010
 
Gulf Standard
Liquefied petroleum gases (LPG) for household use( mixture of commerical propane and butane).
GSO 1180:2021
 
Gulf Standard
Automatic transmission fluid (ATF)

Recently Published from Oil and Gas Sector

GSO ASTM D1078:2022
ASTM D1078:11(2019) 
Gulf Standard
Standard Test Method for Distillation Range of Volatile Organic Liquids
GSO 1206:2022
 
Gulf Standard
Standard Test Method for Base Number of Petroleum Products by Potentiometric Perchloric Acid Titration
GSO ASTM D7603:2022
ASTM D7603:13 
Gulf Standard
Standard Test Method for Determination of Storage Stability and Compatibility in Automotive Gear Oils
GSO ISO 10855-1:2022
ISO 10855-1:2018 
Gulf Standard
Offshore containers and associated lifting sets — Part 1: Design, manufacture and marking of offshore containers