GSO ISO 21307:2022

ISO 21307:2017 
Gulf Standard   Current Edition
· Approved on 12 May 2022 ·

Plastics pipes and fittings — Butt fusion jointing procedures for polyethylene (PE) piping systems

GSO ISO 21307:2022 Files

GSO ISO 21307:2022 Scope

ISO 21307:2017 establishes general principles regarding the procedure used in the construction and quality assessment of butt fusion jointing of polyethylene (PE) piping system components specified in accordance with relevant ISO standards. These components are installed in accordance with the relevant codes of practice, national regulations or industry guidance. Specifically, this document specifies three butt fusion jointing procedures for PE pipes and fittings. These are:

- single low-pressure fusion jointing procedure;

- dual low-pressure fusion jointing procedure;

- single high-pressure fusion jointing procedure.

ISO 21307:2017 takes into consideration the materials and components used, the fusion jointing procedure and equipment and the quality assessment of the completed joint. It can be applied in conjunction with appropriate national regulations and standards.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015 
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993 
Bahraini Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO ISO 22407:2024
ISO 22407:2021 
Gulf Standard
Metallic materials — Fatigue testing — Axial plane bending method
GSO ISO 11114-6:2024
ISO 11114-6:2022 
Gulf Standard
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 6: Oxygen pressure surge testing
GSO EN 14622:2024
EN 14622:2005 
Gulf Standard
Devices to prevent pollution by backflow of potable water - Air gap with circular overflow (restricted) - Family A, type F
GSO ISO 21384-2:2024
ISO 21384-2:2021 
Gulf Standard
Unmanned aircraft systems — Part 2: UAS components