GSO ASTM F2255:2022

Gulf Standard   Current Edition
Approved on  12 May 2022

Standard Test Method for Strength Properties of Tissue Adhesives in Lap-Shear by Tension Loading

Textiles in general
Including colour fastness of textiles
Adhesives
Including adhesive tapes

GSO ASTM F2255:2022 Files

GSO ASTM F2255:2022 Scope

1.1 This test method is intended to provide a means for comparison of the adhesive strengths of tissue adhesives intended for use as surgical adhesives or sealants, or both, on soft tissue. With the appropriate choice of substrate, it may also be used for purposes of quality control in the manufacture of tissue adhesive based medical devices. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Best Sellers From Health Sector

GSO 2528:2016
 
Gulf Technical Regulation
Cosmetic products – Technical Regulation of cosmetic and personal care products claims
BH GSO 2528:2017
GSO 2528:2016 
Bahraini Technical Regulation
Cosmetic products – Technical Regulation of cosmetic and personal care products claims
GSO 2302:2022
 
Gulf Standard
Cosmetic Products – Face Masks
GSO 2680:2021
 
Gulf Standard
Halal medical device – General requirements

Recently Published from Health Sector

GSO ISO 11193-1:2022
ISO 11193-1:2020 
Gulf Standard
Single-use medical examination gloves — Part 1: Specification for gloves made from rubber latex or rubber solution
GSO ISO 13131:2022
ISO 13131:2014 
Gulf Standard
Health informatics — Telehealth services — Quality planning guidelines
GSO EN 455-2:2022
EN 455-2:2015 
Gulf Standard
Medical gloves for single use - Part 2: Requirements and testing for physical properties
GSO ISO 20695:2022
ISO 20695:2020 
Gulf Standard
Enteral feeding systems — Design and testing