GSO ISO 22733-1:2023

ISO 22733-1:2021
Gulf Standard   Current Edition · Approved on 03 May 2023

Road vehicles — Test method to evaluate the performance of autonomous emergency braking systems — Part 1: Car-to-car

GSO ISO 22733-1:2023 Files

English 18 Pages
Current Edition Reference Language
28.41 BHD

GSO ISO 22733-1:2023 Scope

This document specifies a method to evaluate the behaviour of a vehicle equipped with an autonomous emergency braking system (AEBS), or dynamic brake support (DBS) during several accident scenarios. Those accidents occur during a straight-line driving when the vehicle under test (VUT) approaches another vehicle in the same lane. Both vehicles are aligned in longitudinal axis to each other.

The most important part of the vehicle behaviour during these accidents scenarios is the capacity to avoid or mitigate the collision.

Systems requiring driver intervention are not in the scope of this document.

NOTE      Depending on accidentology, only a part of the scenarios can be used for an evaluation of performance. AEB system evaluation based upon this document is limited to longitudinal accident scenarios.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015 
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993 
Bahraini Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO EN 13445-6:2024
EN 13445-6:2021 
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023 
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors