GSO EN 17347:2024

Gulf Standard   Current Edition
· Approved on 31 January 2024 ·

Road vehicles - Machines for mounting and demounting vehicle tyres - Safety requirements

Road vehicles in general
Including testing and recycling of road vehicles
Road vehicle tyres
Including cycle tyres, and tyre retreading and repair processes

GSO EN 17347:2024 Files

GSO EN 17347:2024 Scope

This Standard specifies the safety requisites requirements and their verification for the design and building of machines (see the definition in point 3.2) for mounting and demounting tyres on the vehicles listed below and identified according to the international categories M1, M2, N1, O1, O2, L4 and L5: a) cars b) buses c) lorries d) motor-vehicles for specific or special transport e) mobile homes f) cargo trailers g) car trailers h) motorised quadricycles i) motor vehicles j) mopeds k) agricultural machines (if the wheel/tyre dimensions are compatible with the maximum dimensions indicated in the tyre changer user instructions) The vehicles listed in points a) to f) must have an overall full-load mass no greater than 3.5 t. These machines are designed to ensure the tyre is correctly fitted on the wheel in safe conditions. The standard describes how to eliminate or reduce the risks resulting from the foreseen use (or improper but reasonably foreseeable use) of these machines by the operator during normal operation and service. In addition, it specifies the type of information that the manufacturer must supply with regards to safe working procedures. The Standard describes all the significant hazards (as listed in Table 1) and the danger situations and events relating to these machines. This Standard does not apply to hazards regarding maintenance or repairs carried out by professional maintenance personnel.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015 
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993 
Bahraini Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO ASTM D4778:2024
ASTM D4778:15 
Gulf Standard
Standard Test Method for Determination of Corrosion and Fouling Tendency of Cooling Water Under Heat Transfer Conditions (Withdrawn 2024)
GSO ISO 11114-6:2024
ISO 11114-6:2022 
Gulf Standard
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 6: Oxygen pressure surge testing
GSO ISO 23598:2024
ISO 23598:2021 
Gulf Standard
Mechanical joining of sheet materials — Destructive testing of joints — Specimen dimensions and procedure for mechanized peel testing of single joints
GSO ISO 24513:2024
ISO 24513:2019 
Gulf Standard
Service activities relating to drinking water supply, wastewater and stormwater systems — Vocabulary