GSO EN 17344:2024

EN 17344:2020
Gulf Standard   Current Edition · Approved on 31 January 2024

Agricultural machinery - Self-propelled agricultural and forestry vehicles - Requirements for braking

GSO EN 17344:2024 Files

English 38 Pages
Current Edition Reference Language

GSO EN 17344:2024 Scope

This document applies to wheeled and/or track-laying self-propelled agricultural and forestry vehicles when used on public roads. It specifies the definitions, construction and performance requirements and the means for verification of braking systems on vehicles with a maximum design speed not exceeding 60 km/h. Following items are excluded from the scope of this document: - coupling force control; - endurance braking systems; - Anti-Lock Braking Systems and EBS; - vacuum braking systems; - safety related parts of complex electronic control systems; - trailer braking control systems. NOTE For assisted trailer braking the EU Regulation 2015/68 can be used but before including these requirements into this document, an additional review of 2015/68 is needed.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015 
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993 
Bahraini Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO EN 13445-6:2024
EN 13445-6:2021 
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023 
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors