GSO ISO 23280:2024

ISO 23280:2022
Gulf Standard   Current Edition · Approved on 31 January 2024

Electrically propelled mopeds and motorcycles — Test method for evaluation of energy performance using motor dynamometer

GSO ISO 23280:2024 Files

English 22 Pages
Current Edition Reference Language
54.35 BHD

GSO ISO 23280:2024 Scope

This document specifies a test method to evaluate energy performance of electric motorcycles and mopeds by measuring performance of a test motor system (3.4) to be installed to an electric moped or motorcycle under consideration.

The test is carried out on a motor dynamometer test bench where the traction motor system is connected to a load motor system (3.3) that simulates resistance torque arising from running resistance of vehicle and drive train friction loss and inertia effect.

This method provides estimates of specific energy consumption and range of an electric moped or motorcycle to which the traction motor system is intended to be applied.

This document is only applicable to two-wheeled motorcycles and mopeds.

NOTE      This test method is applicable to motorcycle or moped regardless of types of power transmission devices, such as chains, belts, gears, ratio controllable CVTs, shaft drives, direct drives, etc., once gear ratios (ratio of input to output speed) and transmission efficiencies (ratio of input to output torque) are provided.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015 
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993 
Bahraini Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO EN 13445-6:2024
EN 13445-6:2021 
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023 
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors