GSO ASTM D1142:2024

ASTM D1142:95(2021)
Gulf Standard   Current Edition · Approved on 14 October 2024

Standard Test Method for Water Vapor Content of Gaseous Fuels by Measurement of Dew-Point Temperature

GSO ASTM D1142:2024 Files

GSO ASTM D1142:2024 Scope

1.1 This test method covers the determination of the water vapor content of gaseous fuels by measurement of the dew-point temperature and the calculation therefrom of the water vapor content.

Note 1: Some gaseous fuels contain vapors of hydrocarbons or other components that easily condense into liquid and sometimes interfere with or mask the water dew point. When this occurs, it is sometimes very helpful to supplement the apparatus in Fig. 1 with an optical attachment that uniformly illuminates the dew–point mirror and also magnifies the condensate on the mirror. With this attachment it is possible, in some cases, to observe separate condensation points of water vapor, hydrocarbons, and glycolamines as well as ice points. However, if the dew point of the condensable hydrocarbons is higher than the water vapor dew point, when such hydrocarbons are present in large amounts, they may flood the mirror and obscure or wash off the water dew point. Best results in distinguishing multiple component dew points are obtained when they are not too closely spaced.

FIG. 1 Bureau of Mines Dew-Point Apparatus

 Bureau of Mines Dew-Point Apparatus Bureau of Mines Dew-Point Apparatus

Note 2: Condensation of water vapor on the dew-point mirror may appear as liquid water at temperatures as low as 0 to −10°F (−18 to −23°C). At lower temperatures an ice point rather than a water dew point likely will be observed. The minimum dew point of any vapor that can be observed is limited by the mechanical parts of the equipment. Mirror temperatures as low as −150°F (−100°C) have been measured, using liquid nitrogen as the coolant with a thermocouple attached to the mirror, instead of a thermometer well.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Best Sellers From Oil and Gas Sector

GSO 1180:2021
 
Gulf Standard
Automatic transmission fluid (ATF)
BH GSO 1180:2022
GSO 1180:2021 
Bahraini Standard
Automatic transmission fluid (ATF)
GSO 672:2010
 
Gulf Standard
Liquefied petroleum gases (LPG) for household use( mixture of commerical propane and butane).
GSO 1161:2021
 
Gulf Standard
HLP HYDRAULIC OILS

Recently Published from Oil and Gas Sector

GSO ASTM D7164:2024
ASTM D7164:21 
Gulf Standard
Standard Practice for On-line/At-line Heating Value Determination of Gaseous Fuels by Gas Chromatography
GSO ISO 4259-3:2024
ISO 4259-3:2020 
Gulf Standard
Petroleum and related products — Precision of measurement methods and results — Part 3: Monitoring and verification of published precision data in relation to methods of test
GSO ISO 4266-4:2024
ISO 4266-4:2023 
Gulf Standard
Petroleum and liquid petroleum products — Measurement of level and temperature in storage tanks by automatic methods — Part 4: Measurement of temperature in atmospheric tanks
GSO ASTM D235:2024
ASTM D235:22 
Gulf Standard
Standard Specification for Mineral Spirits (Petroleum Spirits) (Hydrocarbon Dry Cleaning Solvent)