GSO ISO 3739-1:2024
ISO 3739-1:2022
Gulf Standard
Current Edition
·
Approved on
14 October 2024
Industrial tyres and rims — Part 1: Pneumatic tyres (metric series) on 5 degrees tapered or flat base rims — Designation, dimensions and marking
GSO ISO 3739-1:2024 Files
No files for this standard are available in the store currently.
GSO ISO 3739-1:2024 Scope
This document specifies the main requirements of the metric series of pneumatic tyres primarily intended for industrial vehicles, including designations, dimensions and markings. The tyres are based on the following parameters:
— speeds not exceeding 50 km/h;
— use on 5° tapered or flat base rims.
The conversion of code-designated industrial tyres into metric-designated tyres is outside the scope of this document.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993
Bahraini Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO ISO/TR 5262:2025
ISO/TR 5262:2023
Gulf Standard
Motorcycles — Guideline for verification of total running resistance force during mode running on a chassis dynamometer
GSO ISO/IEC 80079-20-1:2025
ISO/IEC 80079-20-1:2017
Gulf Standard
Explosive atmospheres — Part 20-1: Material characteristics for gas and vapour classification — Test methods and data
GSO ISO 22915-10:2025
ISO 22915-10:2023
Gulf Standard
Industrial trucks — Verification of stability — Part 10: Additional stability test for trucks operating in the special condition of stacking with load laterally displaced by powered devices
GSO ISO 19438:2025
ISO 19438:2023
Gulf Standard
Diesel fuel and petrol filters for internal combustion engines — Filtration efficiency using particle counting and contaminant retention capacity