GSO ISO/TS 20459:2025

ISO/TS 20459:2023
Gulf Standard   Current Edition · Approved on 22 April 2025

Road vehicles — Injury risk functions for advanced pedestrian legform impactor (aPLI)

GSO ISO/TS 20459:2025 Files

English 157 Pages
Current Edition Reference Language

GSO ISO/TS 20459:2025 Scope

This document provides definitions, symbols and injury probability functions (IPFs) for the thigh, leg and knee intended to be used with the advanced pedestrian legform impactor (aPLI), a standardized pedestrian legform impactor with an upper mass for pedestrian subsystem testing of road vehicles. They are applicable to impact tests using the aPLI at 11,1 m/s involving:

    vehicles of category M1, except vehicles with a maximum mass above 2 500 kg and which are derived from N1 category vehicles and where the driver’s position, the R-point, is either forward of the front axle or longitudinally rearwards of the front axle transverse centreline by a maximum of 1 100 mm;

    vehicles of category N1, except where the driver’s position, the R-point, is either forward of the front axle or longitudinally rearwards of the front axle transverse centreline by maximum of 1 100 mm;

    impacts to the bumper test area defined by References [1] and [2];

    pedestrian subsystem tests involving use of a legform for the purpose of evaluating compliance with vehicle safety standards.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015 
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993 
Bahraini Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO ECE 148:2026
ECE 148:2023 
Gulf Standard
Uniform provisions concerning the approval of light-signalling devices (lamps) for power-driven vehicles and their trailers
GSO ISO 24596:2026
ISO 24596:2024 
Gulf Standard
Drinking water, wastewater and stormwater systems and services — Guidelines for the planning and implementation of infrastructure hardening for water and wastewater systems
GSO ISO/TR 7035-2:2026
ISO/TR 7035-2:2024 
Gulf Standard
Design and asset management of DIP for water application — Part 2: Design, installation and operation
GSO ISO 2903:2026
ISO 2903:2016 
Gulf Standard
ISO metric trapezoidal screw threads — Tolerances