ISO 12217-1:2002

International Standard   Historical · Approved on 25 April 2002

Small craft — Stability and buoyancy assessment and categorization — Part 1: Non-sailing boats of hull length greater than or equal to 6 m

ISO 12217-1:2002 Files

English 47 Pages
Historical
30.46 BHD

ISO 12217-1:2002 Scope

This part of ISO 12217 specifies methods for evaluating the stability and buoyancy of intact (i.e. undamaged) boats. The flotation characteristics of boats vulnerable to swamping are also encompassed.

The evaluation of stability and buoyancy properties using this part of ISO 12217 will enable the boat to be assigned to a design category (A, B, C or D) appropriate to its design and maximum total load.

This part of ISO 12217 is principally applicable to boats propelled by human or mechanical power of 6 m up to and including 24 m hull length. However, it may also be applied to boats of under 6 m if they do not attain the desired design category specified in ISO 12217-3 and they are decked and have quick-draining recesses which comply with ISO 11812.

This part of ISO 12217 excludes

  • inflatable and rigid-inflatable boats up to 8 m covered by ISO 6185,
  • canoes, kayaks or other boats with a beam of less than 1,1 m,
  • hydrofoils and hovercraft when operating in the dynamically supported mode, and
  • submersibles.

It does not include or evaluate the effects on stability of towing, fishing, dredging or lifting operations, which should be separately considered if appropriate.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 150-2:2015
GSO 150-2:2013 
Bahraini Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 2055-1:2016
GSO 2055-1:2015 
Bahraini Technical Regulation
HALAL FOOD - Part 1 : General Requirements
GSO 2055-1:2015
 
Gulf Technical Regulation
HALAL FOOD - Part 1 : General Requirements

Recently Published

ISO 13909-8:2025
 
International Standard
Coal and coke — Mechanical sampling — Part 8: Methods of testing for bias
ISO/IEC 16466:2025
 
International Standard
Information technology — 3D printing and scanning — Assessment methods of 3D scanned data use in 3D printing
ISO 18960:2025
 
International Standard
Security controls and implementation for third party payment service providers — Guidance and requirements
ISO 5684:2025
 
International Standard
Adhesives — Floor covering adhesives and products for flooring installation — Assessment and classification of low volatile organic compound (VOC) products