ISO 286-2:1988
International Standard
Historical
·
Approved on
09 June 1988
ISO system of limits and fits — Part 2: Tables of standard tolerance grades and limit deviations for holes and shafts
ISO 286-2:1988 Files
English
43 Pages
Historical
30.63 BHD
ISO 286-2:1988 Scope
This part gives of the limit deviations for commonly used tolerance classes calculated from the information given in ISO 286-1. It covers values for the upper and the lower deviations which are illustrated by a figure. It tabulates numerical values for basic sizes from 3 mm up to and including 3150 mm. An annex gives a graphical review of tolerance zones.
Best Sellers
GSO 150-2:2013
Gulf Standard
Expiration dates for food products - Part 2 :
Voluntary expiration dates
BH GSO 150-2:2015
GSO 150-2:2013
Bahraini Standard
Expiration dates for food products - Part 2 :
Voluntary expiration dates
BH GSO 2055-1:2016
GSO 2055-1:2015
Bahraini Technical Regulation
HALAL FOOD - Part 1 : General Requirements
GSO 2055-1:2015
Gulf Technical Regulation
HALAL FOOD - Part 1 : General Requirements
Recently Published
ISO 11040-3:2025
International Standard
Prefilled syringes — Part 3: Seals for dental local anaesthetic cartridges
ISO/IEC 17839-1:2025
International Standard
Information technology — Biometric system-on-card — Part 1: Core requirements
ISO 5403-1:2025
International Standard
Leather — Determination of water resistance of flexible leather — Part 1: Repeated linear compression (penetrometer)
ISO 14577-6:2025
International Standard
Metallic materials — Instrumented indentation test for hardness and materials parameters — Part 6: Instrumented indentation test at elevated temperature