ISO/TR 19688:2019

International Standard   Current Edition · Approved on 11 January 2019

Rotodynamic pumps — Hydraulic performance acceptance test using a model pump

ISO/TR 19688:2019 Files

English 44 Pages
Current Edition
BHD 81.02

ISO/TR 19688:2019 Scope

This document describes hydraulic performance tests (including cavitation tests) using a small size pump (centrifugal, mixed flow or axial pump, hereinafter referred to as a "model pump").

This document is used for pump acceptance tests with a geometrically similar model pump to guarantee the performance of a large size pump manufactured for practical use (hereinafter, a "prototype pump"). This document, however does not preclude a temporary assembly inspection or other tests on the prototype pump. Moreover, it is preferable to conduct the tests with prototype pumps unless

— the capacity of the pump, namely its flow rate and/or its power input, is beyond the limitations of the test facility, though it is difficult to set a criterion for carrying out a model pump test instead of the prototype pump test in terms of the volume rate of flow or the power input,

— a part of the pump is to be constructed by concrete walls and reproduction of the whole assembly is impractical,

— model tests are specified by the purchaser, or

— it is difficult to carry out the prototype pump test due to any other reasons.

This document applies to performance tests under steady operating conditions corresponding to the prototype pump.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
GSO 9:2022
 
Gulf Technical Regulation
Labeling of prepackaged food stuffs
GSO 2055-1:2015
 
Gulf Technical Regulation
Halal Products - Part 1 : General Requirements
GSO 150-1:2013
 
Gulf Technical Regulation
Expiration dates for food products -Part 1 : Mandatory expiration dates

Recently Published

ISO 21815-4:2026
 
International Standard
Earth-moving machinery — Collision warning and avoidance — Part 4: Risk area and risk level for swing and rotation motion
ISO 21611:2026
 
International Standard
Dentistry — Vocabulary for source conclusion for human identification by dental evidence
ISO 4576:2026
 
International Standard
Plastics — Polymer dispersions — Determination of sieve residue
ISO 8553:2026
 
International Standard
Milk — Enumeration of microorganisms — Plate-loop technique at 30 °C