ISO 6621-5:2020

International Standard   Current Edition · Approved on 27 January 2020

Internal combustion engines — Piston rings — Part 5: Quality requirements

ISO 6621-5:2020 Files

English 13 Pages
Current Edition
46.04 BHD

ISO 6621-5:2020 Scope

This document specifies quality aspects that can be defined but that are not normally found on a drawing specification.

It covers the following:

— single‑piece piston rings of grey cast iron or steel;

— multi‑piece piston rings (oil control rings) consisting of cast iron parts and spring components; and

— single‑piece and multi‑piece oil control rings of steel, i.e. oil control rings in the form of strip steel components or steel segments (rails) with spring expander components.

In addition to specifying some of the limits of acceptance relating to inspection measuring principles (covered by ISO 6621‑2), this document also covers those features for which no recognized quantitative measurement procedures exist and which are only checked visually with normal eyesight (glasses if worn normally) and without magnification. Such features (superficial defects) are additional to the standard tolerances of ring width, radial wall thickness and closed gap.

This document does not establish acceptable quality levels (AQL), it being left to manufacturer and customer to decide the appropriate levels jointly. In this case, the recommendations of ISO 2859‑1 are followed.

This document specifies the quality requirements of piston rings for reciprocating internal combustion engines for road vehicles and other applications. It is applicable to all such rings of a nominal diameter from 30 mm up to and including 200 mm.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 150-2:2015
GSO 150-2:2013 
Bahraini Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 2055-1:2016
GSO 2055-1:2015 
Bahraini Technical Regulation
HALAL FOOD - Part 1 : General Requirements
GSO 2055-1:2015
 
Gulf Technical Regulation
HALAL FOOD - Part 1 : General Requirements

Recently Published

ISO 20589:2025
 
International Standard
Glass in building — Determination of the emissivity
ISO 11265:2025
 
International Standard
Environmental solid matrices — Determination of the specific electrical conductivity
ISO 11465:2025
 
International Standard
Sludge and solid environmental matrices — Determination of dry residue or water content and calculation of the dry matter fraction on a mass basis
ISO 9350:2025
 
International Standard
Corrosion of metals and alloys — Testing method of corrosion resistance for hafnium at high temperature and pressure