ISO 10683:2018

International Standard   Current Edition · Approved on 13 August 2018

Fasteners — Non-electrolytically applied zinc flake coating systems

ISO 10683:2018 Files

English 31 Pages
Current Edition
BHD 70.87

ISO 10683:2018 Scope

This document specifies requirements for non-electrolytically applied zinc flake coating systems for steel fasteners. It is applicable to coatings:

— with or without hexavalent chromium;

— with or without top coat;

— with or without lubricant (integral lubricant and/or subsequently added lubricant).

It is applicable to bolts, screws, studs and nuts with ISO metric thread, to fasteners with non-ISO metric thread, and to non-threaded fasteners such as washers, pins, clips, etc.

This document does not specify requirements for such fastener properties as weldability or paintability. It is not applicable to mechanically applied zinc coatings.

NOTE Coatings in accordance with this document are especially used for high strength fasteners (≥ 1 000 MPa) to avoid risk of internal hydrogen embrittlement (IHE — see 4.4).

Information for design and assembly of coated fasteners is given in Annex A.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
GSO 2055-1:2015
 
Gulf Technical Regulation
Halal Products - Part 1 : General Requirements
GSO 9:2022
 
Gulf Technical Regulation
Labeling of prepackaged food stuffs
GSO 150-1:2013
 
Gulf Technical Regulation
Expiration dates for food products -Part 1 : Mandatory expiration dates

Recently Published

ISO 21611:2026
 
International Standard
Dentistry — Vocabulary for source conclusion for human identification by dental evidence
ISO 21815-4:2026
 
International Standard
Earth-moving machinery — Collision warning and avoidance — Part 4: Risk area and risk level for swing and rotation motion
ISO 4576:2026
 
International Standard
Plastics — Polymer dispersions — Determination of sieve residue
ISO 8553:2026
 
International Standard
Milk — Enumeration of microorganisms — Plate-loop technique at 30 °C