ISO 20233-1:2018

مواصفة قياسية دولية   الإصدار الحالي
اعتمدت بتاريخ  23 فبراير 2018

Ships and marine technology — Model test method for propeller cavitation noise evaluation in ship design — Part 1: Source level estimation

المحركات البحرية ونظم الدفع المروحي
* مواصفات محركات الاحتراق الداخلي للاستخدام العام، انظر 27.020

ملفات الوثيقة ISO 20233-1:2018

الإنجليزية 13 صفحات
الإصدار الحالي
39.63 BHD

مجال الوثيقة ISO 20233-1:2018

ISO 20233-1:2018 specifies a model test method for propeller cavitation noise evaluation in ship design.

The procedure comprises reproduction of noise source, noise measurements, post processing and scaling. The target noise source is propeller cavitation. Thus, this document describes the test set-up and conditions to reproduce the cavitation patterns of the ship based on the similarity laws between the model and the ship. The propeller noise is measured at three stages. The measurement targets for each stage are propeller cavitation noise, background noise, and transmission loss. For the source level evaluations, corrections for the background noise and the transmission loss are applied to the measured propeller cavitation noise. Finally, the full-scale source levels are estimated from the model scale results using a scaling law.

الأكثر مبيعاً

GSO 150-2:2013
 
مواصفة قياسية خليجية
فترات صلاحية المنتجات الغذائية - الجزء الثاني : فترات الصلاحية الاختيارية
BH GSO 150-2:2015
GSO 150-2:2013 
مواصفة قياسية بحرينية
فترات صلاحية المنتجات الغذائية - الجزء الثاني : فترات الصلاحية الاختيارية
BH GSO 150-1:2015
GSO 150-1:2013 
لائحة فنية بحرينية
فترات صلاحية المنتجات الغذائية - الجزء الأول : فترات الصلاحية الإلزامية
GSO 150-1:2013
 
لائحة فنية خليجية
فترات صلاحية المنتجات الغذائية - الجزء الأول : فترات الصلاحية الإلزامية

اعتمدت مؤخراً

ISO 21978:2023
 
مواصفة قياسية دولية
Air to water heat pumps — Testing and rating at part load conditions and calculation of seasonal coefficient of performance for space heating
ISO 12643-2:2023
 
مواصفة قياسية دولية
Graphic technology — Safety requirements for graphic technology equipment and systems — Part 2: Prepress and press equipment and systems
ISO 4266-2:2023
 
مواصفة قياسية دولية
Petroleum and liquid petroleum products — Measurement of level and temperature in storage tanks by automatic methods — Part 2: Measurement of level in marine vessels
ISO 12643-3:2023
 
مواصفة قياسية دولية
Graphic technology — Safety requirements for graphic technology equipment and systems — Part 3: Binding and finishing equipment and systems