ISO 23555-2:2022

 
International Standard   Current Edition
· Approved on 11 January 2022 ·

Gas pressure safety and control devices for use in gas transmission, distribution and installations for inlet pressures up to and including 10 MPa — Part 2: Gas pressure regulator

ISO 23555-2:2022 Files

English 58 Pages
Current Edition
84.21 BHD

ISO 23555-2:2022 Scope

This document specifies safety, constructional, performance, testing and documentation requirements for gas pressure regulators for use in gas transmission and distribution installations (hereafter referred to as regulators).

This document is applicable to regulators with operating pressures greater than 500 kPa and up to and including 10 MPa (100 bar) and nominal diameters up to DN 400 for use with fuel gases as natural gas, manufactured gas, biomethane or liquefied petroleum gas (LPG).

This document is applicable to:

—    test methods which are intended for product type test, routine tests and product surveillance tests;

—    regulators which use the pipeline gas as a source of control energy unassisted by any external power source;

—    regulators integrating on the same body a second regulator, used as monitor, complying with the requirements in this document;

—    regulators integrating a safety shut off device (SSD) according to ISO 23555-3;

—    regulators incorporating a creep (venting) relief device and/or a vent limiter complying with the requirements in this document.

This document does not apply to:

—    regulators upstream from/on/in domestic gas‑consuming appliances which are installed downstream of domestic gas meters;

—    regulators designed to be incorporated into pressure control systems used in service lines (pipework from the main pipework in a gas infrastructure to the point of delivery of the gas) with declared volumetric flow rate ≤ 200 m3/h at normal conditions and declared inlet pressure ≤ 500 kPa (5 bar);

—    industrial process control valves, such as IEC 60534 (all parts);

—    regulators used in aggressive/sour gas environments (gas environments containing water and H2S are considered sour) or severely corrosive conditions;

—    regulators in service conditions with renewables (e.g. H2NG with hydrogen more than 10 %) and/or waste gases (e.g. biogas etc.), if additional information is not provided (e. g. contaminant, liquid, etc.).

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 150-2:2015
GSO 150-2:2013 
Bahraini Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 2055-1:2016
GSO 2055-1:2015 
Bahraini Technical Regulation
HALAL FOOD - Part 1 : General Requirements
GSO 2055-1:2015
 
Gulf Technical Regulation
HALAL FOOD - Part 1 : General Requirements

Recently Published

ISO 22476-16:2024
 
International Standard
Geotechnical investigation and testing — Field testing — Part 16: Borehole shear test
ISO 16733-1:2024
 
International Standard
Fire safety engineering — Selection of design fire scenarios and design fires — Part 1: Selection of design fire scenarios
ISO 21771-1:2024
 
International Standard
Cylindrical involute gears and gear pairs — Part 1: Concepts and geometry
ISO 5727:2024
 
International Standard
Accessibility and usability of the built environment — Accessibility of immovable cultural heritage — Principles and methodology for interventions