ISO 10360-5:2020

International Standard   Current Edition · Approved on 31 March 2020

Geometrical product specifications (GPS) — Acceptance and reverification tests for coordinate measuring systems (CMS) — Part 5: Coordinate measuring machines (CMMs) using single and multiple stylus contacting probing systems using discrete point and/or scanning measuring mode

ISO 10360-5:2020 Files

English 42 Pages
Current Edition
83.95 BHD

ISO 10360-5:2020 Scope

This document specifies acceptance and periodic reverification tests of CMM performance with contacting probing systems and is only applicable to CMMs using:

— any type of contacting probing system; and

— spherical or hemispherical stylus tip(s).

NOTE CMM probing performance tests are specified by the maximum permissible errors (MPEs), due to the impracticality of isolating the performance of the probing system from that of the CMM, even on a small artefact such as a test sphere.

This document applies to CMMs supplied with any of the following:

a) single-stylus probing systems;

b) multi-stylus probing systems with fixed multiple styli attached to a single probe (e.g. "star" stylus);

c) multiple probing systems such as those with a stylus for each of their probes;

d) systems with articulating probing systems;

e) stylus and probe changing systems;

f) manual (non-driven) and automated CMMs;

g) installations including a scanning probe, capable of being used in a scanning mode.

This document is not applicable to non-contacting probing systems, which require different testing procedures.

The term ?combined CMM and multi-stylus probing system size error' has been shortened to ?multi-stylus size error' for convenience. This applies in similar cases.

If it is desirable to isolate the probing system performance as far as is practical, the influence of the CMM can be minimized but not eliminated. See Annex C for more information.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 150-2:2015
GSO 150-2:2013 
Bahraini Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 2055-1:2016
GSO 2055-1:2015 
Bahraini Technical Regulation
HALAL FOOD - Part 1 : General Requirements
GSO 2055-1:2015
 
Gulf Technical Regulation
HALAL FOOD - Part 1 : General Requirements

Recently Published

ISO 1952:2025
 
International Standard
Coal — Determination of extractable metals in dilute hydrochloric acid
ISO 5834-1:2025
 
International Standard
Implants for surgery — Ultra-high-molecular-weight polyethylene — Part 1: Powder form
ISO 5834-3:2025
 
International Standard
Implants for surgery — Ultra-high-molecular-weight polyethylene — Part 3: Accelerated ageing methods after gamma irradiation in air
ISO 15238:2025
 
International Standard
Coal — Determination of total cadmium