ISO/TS 21364-1:2021

International Standard   Historical · Approved on 21 May 2021

Domestic gas cooking appliances — Safety — Part 1: General requirements

ISO/TS 21364-1:2021 Files

English 79 Pages
Historical
BHD 94.8

ISO/TS 21364-1:2021 Scope

This document specifies the safety requirements for domestic gas cooking appliances. These appliances are freestanding, built-in or table-top and are intended to be used indoors. This document applies to the gas sections of the appliances and their component parts (e.g. combined gas-electric cooking appliances). This document does not apply to:

a) electrical heated elements as part of the appliance;

b) outdoor appliances;

c) appliances supplied at pressures greater than the maximum pressure of the test gases;

d) cook stoves, covered by the standards being developed in ISO/TC 285

In general, it does not take into account children playing with the appliance.

NOTE 1    For requirements of electrical safety refer to the IEC 60335 standard series.

NOTE 2    Attention is drawn to the fact that

−      for appliances intended to be used in vehicles or on board of ships or aircrafts, additional requirements could be necessary;

−      in many countries additional requirements are specified by the national health authorities, the national water supply authorities and similar authorities

This document does not cover requirements relating to gas cylinders, their pressure regulators and their connections.

This document does not cover requirements for gas installation.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 150-2:2015
GSO 150-2:2013 
Bahraini Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 9:2023
GSO 9:2022 
Bahraini Technical Regulation
Labeling of prepackaged food stuffs
GSO 9:2022
 
Gulf Technical Regulation
Labeling of prepackaged food stuffs

Recently Published

ISO 14855-2:2026
 
International Standard
Determination of the ultimate aerobic biodegradability of plastic materials under controlled composting conditions — Method by analysis of evolved carbon dioxide — Part 2: Gravimetric measurement of carbon dioxide evolved in a laboratory-scale test
ISO/TR 5503:2026
 
International Standard
Preparation of steel substrates before application of paints and related products — Non-visible residues after surface preparation with single use abrasives — Relationship between conductivity (Bresle) measurements and surface soluble salt composition on panels blasted with single-use mineral abrasives
ISO 4683-3:2026
 
International Standard
Raw sheep skins — Part 3: Guidelines for grading on the basis of mass and size
ISO/IEC 25791-1:2026
 
International Standard
Information technology — OpenID Connect FAPI Security Profile 1.0 — Part 1: Baseline