ISO/TS 4985:2023

مواصفة قياسية دولية   الإصدار الحالي · اعتمدت بتاريخ ٣١ يوليو ٢٠٢٣

Milk and milk products — Determination of alkaline phosphatase activity — Fluorimetric microplate method

ملفات الوثيقة ISO/TS 4985:2023

الإنجليزية 21 صفحات
الإصدار الحالي
BHD 61.73

مجال الوثيقة ISO/TS 4985:2023

This document specifies a fluorimetric microplate method for the determination of alkaline phosphatase (ALP, EC 3.1.3.1)[5] activity in raw and heat-treated whole milk, semi-skimmed milk, skimmed milk, cream, flavoured milks and cheeses.

This method is applicable to milk and milk-based drinks from cows, sheep and goats. Although the method was not tested in milk from other species, it can also be applicable to milk from other species with a similar composition to cow, sheep or goat milk, such as milk from buffalo and camelids. It is also applicable to milk powder after reconstitution and soft, semi-hard and hard cheeses provided that the mould is only on the surface of the cheese and not also in the inner part (e.g. blue veined cheeses). For large hard cheeses, specific conditions of sampling apply (see Clause 7).

NOTE            This method was adapted from Reference [6].

الأكثر مبيعاً

GSO 150-2:2013
 
مواصفة قياسية خليجية
فترات صلاحية المنتجات الغذائية - الجزء الثاني : فترات الصلاحية الاختيارية
BH GSO 150-2:2015
GSO 150-2:2013 
مواصفة قياسية بحرينية
فترات صلاحية المنتجات الغذائية - الجزء الثاني : فترات الصلاحية الاختيارية
GSO 9:2022
 
لائحة فنية خليجية
بطاقات المواد الغذائية المعبأة
BH GSO 9:2023
GSO 9:2022 
لائحة فنية بحرينية
بطاقات المواد الغذائية المعبأة

اعتمدت مؤخراً

ISO 18615-1:2026
 
مواصفة قياسية دولية
Traditional Chinese medicine — Electric radial pulse tonometric devices — Part 1: General requirements
ISO 21388-1:2026
 
مواصفة قياسية دولية
Acoustics — Hearing aid fitting management (HAFM) — Part 1: General process
ISO 20915:2026
 
مواصفة قياسية دولية
Life cycle inventory calculation methodology for steel products
ISO 11607-3:2026
 
مواصفة قياسية دولية
Packaging for terminally sterilized medical devices — Part 3: Requirements for process development for forming, sealing and assembly