ISO/TS 20065:2022

International Standard   Current Edition · Approved on 19 December 2022

Acoustics — Objective method for assessing the audibility of tones in noise — Engineering method

ISO/TS 20065:2022 Files

English 33 Pages
Current Edition
BHD 72.46

ISO/TS 20065:2022 Scope

This document describes a method for the objective determination of the audibility of tones in environmental noise.

This document is intended to augment the usual method for evaluation on the basis of aural impression, in particular, in cases in which there is no agreement on the degree of the audibility of tones. The method described can be used if the frequency of the tone being evaluated is equal to, or greater than, 50 Hz. In other cases, if the tone frequency is below 50 Hz, or if other types of noise (such as screeching) are captured, then this method cannot replace subjective evaluation.

NOTE      The procedure has not been validated below 50 Hz.

The method presented herein can be used in continuous measurement stations that work automatically.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 150-2:2015
GSO 150-2:2013 
Bahraini Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
GSO 9:2022
 
Gulf Technical Regulation
Labeling of prepackaged food stuffs
BH GSO 9:2023
GSO 9:2022 
Bahraini Technical Regulation
Labeling of prepackaged food stuffs

Recently Published

ISO 20816-3:2026
 
International Standard
Mechanical vibration — Measurement and evaluation of machine vibration — Part 3: Industrial machines with operating speeds between 120 r/min and 30 000 r/min
ISO 20816-1:2026
 
International Standard
Mechanical vibration — Measurement and evaluation of machine vibration — Part 1: General guidelines
ISO 23375:2026
 
International Standard
Intelligent transport systems — Collision evasive lateral manoeuvre systems (CELM) — Requirements and test procedures
ISO 18722-2:2026
 
International Standard
Tobacco heating systems — Determination of aerosol collected mass and nicotine in the aerosol with a puffing regime according to the ISO 5501 series — Part 2: Aerosol heated tobacco products (aHTPs)