ISO 14155:2026

International Standard   Current Edition · Approved on 23 March 2026

Clinical investigation of medical devices for human subjects — Good clinical practice

ISO 14155:2026 Files

English 85 Pages
Current Edition
BHD 105.39

ISO 14155:2026 Scope

This document specifies good clinical practice (GCP) for the design, conduct, recording and reporting of clinical investigations carried out in human subjects to assess the clinical performance or effectiveness and safety of medical devices.

For post-market clinical investigations, the principles set forth in this document are intended to be followed as far as relevant, considering the nature of the clinical investigation (see Annex I).

This document specifies the general requirements intended to

  • protect the rights, safety and well-being of human subjects, users or other persons,
  • ensure the scientific conduct of the clinical investigation and the credibility of the clinical investigation results,
  • define the responsibilities of the sponsor and principal investigator, and
  • assist sponsors, investigators, ethics committees, regulatory authorities and other bodies involved in the conformity assessment of medical devices.

Other standards or national requirements can also apply to the investigational device(s) under consideration or the clinical investigation(s).

NOTE            For Software as a Medical Device (SaMD), where appropriate, demonstration of the analytical validity (the SaMD’s output is accurate for a given input), the scientific validity (the SaMD’s output is associated to the intended clinical condition/physiological state), and clinical performance (the SaMD’s output yields a clinically meaningful association to the target use) of the SaMD, the requirements of this document apply as far as relevant (see Reference [5]). Justifications for exemptions from this document can consider the uniqueness of indirect contact between subjects and the SaMD.

This document does not apply to in vitro diagnostic medical devices. However, there can be situations, dependent on the device and national or regional requirements, where users of this document can consider whether either specific sections or requirements of this document, or both, can be applicable.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 150-2:2015
GSO 150-2:2013 
Bahraini Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
GSO 9:2022
 
Gulf Technical Regulation
Labeling of prepackaged food stuffs
BH GSO 9:2023
GSO 9:2022 
Bahraini Technical Regulation
Labeling of prepackaged food stuffs

Recently Published

ISO 14855-2:2026
 
International Standard
Determination of the ultimate aerobic biodegradability of plastic materials under controlled composting conditions — Method by analysis of evolved carbon dioxide — Part 2: Gravimetric measurement of carbon dioxide evolved in a laboratory-scale test
ISO/TR 5503:2026
 
International Standard
Preparation of steel substrates before application of paints and related products — Non-visible residues after surface preparation with single use abrasives — Relationship between conductivity (Bresle) measurements and surface soluble salt composition on panels blasted with single-use mineral abrasives
ISO 4683-3:2026
 
International Standard
Raw sheep skins — Part 3: Guidelines for grading on the basis of mass and size
ISO/IEC 25791-1:2026
 
International Standard
Information technology — OpenID Connect FAPI Security Profile 1.0 — Part 1: Baseline