ISO 21364-1:2025

International Standard   Current Edition · Approved on 03 June 2025

Domestic gas cooking appliances — Safety — Part 1: General requirements

ISO 21364-1:2025 Files

English 83 Pages
Current Edition
BHD 103.61

ISO 21364-1:2025 Scope

This document specifies the safety requirements for domestic gas cooking appliances. This covers appliances that are freestanding, built-in or table-top and are intended to be used indoors. This document applies to the gas sections of the appliances and their component parts (e.g. combined gas-electric cooking appliances). This document does not apply to:

a)       electrical heated elements as part of the appliance;

b)       outdoor appliances;

c)        appliances supplied at pressures greater than the maximum pressure of the test gases;

d)       cook stoves covered by the standards developed by ISO/TC 285.

In general, it does not take into account children playing with the appliance.

NOTE 1        For requirements regarding electrical safety, refer to the IEC 60335 series.

NOTE 2        Attention is drawn to the fact that:

—      for appliances intended to be used in vehicles or on board of ships or aircrafts, additional requirements can apply;

—      in many countries, additional requirements are specified by the national health authorities, the national water supply authorities and similar authorities.

This document does not cover requirements relating to gas cylinders, their pressure regulators and their connections.

This document does not cover requirements for gas installation.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
BH GSO 150-2:2015
GSO 150-2:2013 
Bahraini Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
GSO 9:2022
 
Gulf Technical Regulation
Labeling of prepackaged food stuffs
BH GSO 9:2023
GSO 9:2022 
Bahraini Technical Regulation
Labeling of prepackaged food stuffs

Recently Published

ISO 787-24:2026
 
International Standard
General methods of test for pigments and extenders — Part 24: Photometric methods for determining the relative tinting strength of coloured pigments and the relative scattering power of white pigments
ISO 3219-3:2026
 
International Standard
Rheology — Part 3: Test procedure and examples for the evaluation of results when using rotational and oscillatory rheometry
ISO 3116:2026
 
International Standard
Magnesium and magnesium alloys — Wrought magnesium and magnesium alloys
ISO 19123-2:2026
 
International Standard
Geographic information — Schema for coverage geometry and functions — Part 2: Coverage implementation schema